
Page 8
© 2000 Saftronics, Inc.
S
TART-UP GUIDE
GP5 / FP5
www.saftronics.com
Example 5: Remote Start/Stop (3-wire) & Speed Changes via the Speed Pot
This configuration is best utilized when a person has control of the inverter and the application. Both potentiometers
should be rated between 2kΩ and 5kΩ of resistance and rated at least 1/4 watt each. The trim pot. is optional, but
without it the manual speed pot. will run the inverter at full speed when the pot is only turned 2/3 of a full turn.
Operation
By momentarily closing push-button (PB1), while push-button (PB2) is closed, the inverter will run
up to the frequency (speed) set into U-01Frequency Ref..
By opening push-button (PB2) at any time, the inverter will stop.
When switch (SW1) is in the open position the motor will run in the forward direction. If the
switch (SW1) is closed, the motor will reverse direction.
The frequency reference (speed) is proportional to the signal level present on terminal FV
0V=0Hz, 5V=30Hz and 10V=60Hz.
When the LOCAL/REMOTE key is pressed, the inverter will act as Example 1.
Table 5: Programming needed for Remote (3-wire) & Speed Changes via Speed
Potentiometer
Note: After the changes are made, the DRIVE, SEQ and STOP LED’s will be lit.
retemaraPyalpsiDnoitpircseD
100N
drowssaP
8
.tesereriw-2amrofreplliwretrevniehT
:NOITUACyrotcafriehtotsretemarapllastesretemarapsihT
retrevniehtnehW.tsoleblliwsgnittessuoiverplladnasgnittes
.1foeulavaotsnruterretemarapeht,teserehtsetelpmoc
100N
drowssaP
3
.retrevniehtniretemarapllasseccaot,3foeulavaotegnahC
91/810N
emiTleccA
emiTleceD
llufotpotsmorF/emiTnoitareleceDdnaemiTnoitareleccA
.deeps
330N
ALFdetaRrotoM
Ax.x
ehtstessiht(etalpemanrotomehtmorfspmadaolllufehtretnE
.)levelnoitcetorprotom
FC
G
FI
FV
FS
S1
S2
S5
S4
S3
S6
SC
GP5/FP5
Control Wiring
Shield to
Terminal G
(PB1)
(PB2)
Start
Stop
SW1
Forward
Reverse
Start
Stop
FWD/REV
+15Vdc
Shield
Drain Wire
Frequency Ref.
0 to 10VDC
Analog
Common
Optional
Trim Pot
(R2)
Speed Pot
(R1)
2.5KΩ
2.5KΩ
For more info on
the multi-function
inputs ref. page 78
in the GP5/FP5
Instruction manual
Komentáře k této Příručce