Saftronics GP5 Series Manuál s instrukcemi Strana 3

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 11
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 2
Page 3
© 2000 Saftronics, Inc.
S
TART-UP GUIDE
GP5 / FP5
www.saftronics.com
7. Control Terminal Wiring- Remove power and wait until the Charge LED goes out before making control
connections. The size of the control wiring should be between 16AWG and 20AWG wire. All control
wiring should be shielded, with the shield grounded to the inverter’s chassis ground and the other end
left unconnected. All the control wiring terminates on the terminal strip located on the control card (the
card that plugs into the keypad).
6. Choose a Configuration from the table below, each example listed below contains a control wiring
diagram, operation explanation, and all the necessary programming (associated with that mode). The
GP5/FP5 inverter can be controlled in several more modes than explained in the start-up guide. The
following configurations are generally considered the most commonly used in the field. For a more
complete explanation, please refer to the GP5/FP5 Instruction Manual part # 027-2005F or download a
copy from our website, www.saftronics.com.
Table A: Inverter Configuration Examples
Terminal FV Bias
0.0%
Motor rated FLA
xx.xA
PID Mode
Disabled
Energy Sav Sel
Disabled
Parameter n002
Oper Mode
Select
V/f Selection
60Hz Preset
Terminal FV Gain
100%
Output Frequency
0.0 Hz
Output Amps
0.0 A
Output Power
0.0 Kw
Forward/Reverse
For
Frequency Ref.
0.0 Hz
Monitor U-01
Frequency Ref
Decel Time 1
0.0 Sec
Input Voltage
230.0 VAC
Accel Time 1
0.0 Sec
U-01 Frequency Ref
U-02 Output Frequency
U-03 Output Current
U-04 Output Voltage
U-05 DC Bus Voltage
U-06 Output Power
U-07 Input Term. Status
U-08 Inverter Status
U-09 Past Four Faults
U-10 Software Revision
U-11 Elapsed Time Meter
U-12 Elapsed Time Meter
U-13 PID Feedback value
U-15 Kilowatt-hour Meter
U-16 Kilowatt-hour Meter
Home Position
Home Position
= DSPL key
ecneuqeS
)potS/tratS(
ecnerefeR
deepS(
)segnahC
noitpircseD
elpmaxE
egaP
dapyeKdapyeK
pu-tratslatinimrofrepotdedeengniriwlortnocoN
.rotomehtfonoitatorkcehcdna
1elpmaxE
2egaP
eriw-2dapyeK
deeps,)CLP(tcatnocetomerehtaivpotS/tratS
.dapyekehtaivsegnahc
2elpmaxE
3egaP
eriw-3dapyeK
deeps,snottubhsupetomerehtaivpotS/tratS
.dapyekehtaivsegnahc
3elpmaxE
4egaP
eriw-2Am02ot4
ecruosetomeramorfsegnahcdeepsdnapotS/tratS
.CLPasahcus
4elpmaxE
6egaP
eriw-3
cdV01ot0
).toPdeepS(
deeps,snottubhsupetomerehtaivpotS/tratS
ecruoslanretxero.topdeepsetomeraaivsegnahc
.)cdV01ot0(
5elpmaxE
7egaP
eriw-2
tcatnoC
serusolC
deepsdna)CLP(tcatnocetomerehtaivpotS/tratS
.ecnerefergolanarosdeepstneserpaivsegnahc
6elpmaxE
9egaP
Zobrazit stránku 2
1 2 3 4 5 6 7 8 9 10 11

Komentáře k této Příručce

Žádné komentáře